A featured contribution from Leadership Perspectives: a curated forum reserved for leaders nominated by our subscribers and vetted by the Construction Tech Review Advisory Board.

Bryden Wood

Jaimie Johnston, Director, Head of Global Systems

Many Innovations, Just One Process

Jaimie Johnston

Jaimie Johnston

There is lots of talk about change across the industry; from DfMA (design for manufacture and assembly) to Digital Twins, from MMC to Platforms, buzz words are rife. However, they are often talked about as though they are individual, separate initiatives; solutions in isolation. As if we can sprinkle bits of innovation here and there into a traditional construction process and hope to get far better results.

To create the change we want, we need to create a wholly new approach with a guiding logic where everything works together as part of one process. Technology isn’t here to help us ‘do traditional construction better.’ It’s here to help us be smarter, to inform a new way of thinking about design and construction.

It is increasingly accepted within the industry that many of the well-documented challenges will be solved by a move to a more manufacturing-led approach. It is often said that in construction, every project is a prototype; one crucial aspect of DfMA is that learning can be captured and built on; standardised repeatable solutions will lead to improvements over time. ‘Continual improvement’ is the manufacturing mantra that led to vast gains in quality and productivity, achieved through accumulating many marginal gains in product and process. Contrast this to construction’s equivalent ‘constant reinvention,’ and it is clear why we lag.

However, as the sophistication of the delivery process increases, the nature of the digital work-flow must adapt to support it. There is little point in creating a highly manufactured solution that is described using traditional drawings and documents. Conversely, it doesn’t make sense to develop an advanced digital workflow that is used to drive a traditional construction process.

If we start to think of our future assets as unique configurations of standard components, it becomes more obvious that we need a new set of tools to help. Rather than start with a ‘blank sheet of paper,’ we should build on an existing pool of systems and solutions. The creative challenge is in finding the best configuration for a given brief and site and enhancing our ‘kit of parts’ to make it better performing and more adaptable. We should remember that the term DfMA describes the process – DESIGN for manufacture and assembly – not the product.

The issue is that we need to find a way to engage a large community of designers in this new process, by providing digital tools to accelerate their adoption of new ways of working. Rather than carrying out a traditional design process and retrofitting DfMA, we need to provide the tools that facilitate this thinking from the earliest stages of design.

This led us to develop the new free to use, web-based, open-source digital configurators that we launched recently: PRISM (for housing) and SEISMIC (for schools). PRISM embeds manufacturing logic for a range of delivery systems; from modular to flat pack. It’s critical that we can keep our options open in the design phase, to ensure that we chose the delivery system that best fits the site and builds requirements. Configurators help designers do just that. They enable the consideration of many different possibilities, creating a huge range of different options, which can then be narrowed down based on the client value drivers and site-specific context. 

The articles from these contributors are based on their personal expertise and viewpoints, and do not necessarily reflect the opinions of their employers or affiliated organizations.
Top